Machine Parameter: Laser Control

Laser type

1)Fiber: Indicates current laser type is fiber laser.

2)CO2: Indicates the current laser type is CO2 laser.

3)YAG: Indicates the current laser type is YAG laser.

4)SPI: Indicates the current laser type is SPI laser.

5)QCW: Indicates the current laser type is QCW laser.

Frequency

1)Min value: The laser can set the minimum frequency.

2)Max value: Laser can set the maximum frequency.

3)Frequency delay: Delay time required when the laser changes frequency.

4)PWM opening delay: Time delay of rising edge and rising edge of Gate when PWM is on.

Power

Power map: Set the user-defined power ratio and the actual power ratio. If the power ratio set by the user is not in the dialog box, the linear interpolation is used.

CO2

1)Enable tickle: Enables the preionization signal. Some manufacturers CO2 lasers need this signal to work properly, such as the United States SYNRAD's laser.

2)Pulse freq: Pulse frequency of preionization signal. 3)Pulse width: Pulse width of preionization signal.

YAG

1)Firstpulsekiller: The duration of the first pulse suppression signal when the laser is on.

2)Q switch open when FPK end: The Q switch is turned on when the laser is turned on and so on after the first pulse suppression signal is completed. Otherwise, the first pulse suppression signal is turned on and the Q switch is turned on..

3)Enable current output: Enables the analog power signal output of the control card.

4)Current map: Set the user-defined current ratio and the actual current ratio. If the current ratio set by the user is not in the dialog box, the linear interpolation value is used.

FIBER

1)Type: Fiber laser class.

2)MO always open: After enabling, the MO signal is always on.

3)Leakage treatment: After each marking a line segment, the MO signal will be turned off and turned on the next time.

4)Open MO delay: The MO signal gives the AP signal after the delay. If the setting is too small, it may damage the laser.

5)Enable pulse width setting: Whether the pulse width is enabled.

6)Change pulse duration delay: Delay time for the laser to change pulse width.

7)Pulse width index mode: Pulse width is represented by an index.

SPI

1)Simmer cur: SPI laser standby power.

2)Change wave delay: The time from changing the waveform to the light output takes time due to the laser changing the mode.

QCW-Enable waveform output

1)The remote control signal is low level: Control signal high and low effective setting.

2)The error reset signal is active low: Yes, reset signal is low, no, reset signal is high.

Other

1)Enable laser delay time for the first time: Whether to enable the first time to open the laser delay time.

2)Laser on time: When the laser is turned on, the galvanometer starts to move after this time delay.

3)Discheck the status of the laser: It is forbidden to check the laser status before processing.