Before, the red light was horizontal, so there was no problem in marking. After I turned it on today, it suddenly changed to such a…
READ MORE ->
Laser Marking
Ezcad Has No Response or Crashes When Opening PLT Files
The most likely reason is that the PLT file is too large.
The Laser Marking Speed Is Very Slow?
The laser marking speed is very slow, and adjust the speed on the right side of the software EzCad does not work? Try changing the fill…
READ MORE ->
The Laser Marking Characters Are Reversed?
The characters marked with the laser marker are reversed. How to adjust? Check if the Use the correction file is not used in the key Param(F3). If you are using…
READ MORE ->
How to Mark the Pattern Lines Thicker?
This is related to the laser outlet. If it is a co2 laser, the line will be slightly thicker by increasing the power. The thickness of the lines marked by fiber…
READ MORE ->
Laser Marking QR Code Is Not Clear?
As shown in the picture, the laser marking QR code in the middle is not clear, and it feels like the QR code is obviously engraved into…
READ MORE ->
How to Print Out the Effect of Embossed Text by Ezcad2?
There are two options for zooming. One is to use a 2D galvo, add a motorized z-axis to achieve zoom, and use EZCAD3+DLC2-2D + to enable the 3d…
READ MORE ->
How to Solve the Problem: EzCad2 Keeps Marking Automatically?
Check Param(F3) – Port – Start Marking IO, see if it is low level, if it is, change it to high level.
It Prompts “Can not open correct file” When Open EzCad2?
It is because there is no correction file and the “Use the correction file” in the F3 parameter is checked. If there is a correction file, please select…
READ MORE ->
Laser to Not Emit Light When Connected to the Board
There are generally the following possibilities. A. Not on the focal plane. After marking a small circle continuously, manually adjust the distance between the galvanometer…
READ MORE ->