In the software interface, key “F3” parameters – Field – After Mark Goto, check the “Galvo Center”.
EzCad2
Can Ezcad Red Light Show a Specific Outline Instead of a Box?
Key F3 Parameters – Other – Red light pointer, check the “Enable Show contour”.
The Red Light Suddenly Change to Be Vertical From Horizontal
Before, the red light was horizontal, so there was no problem in marking. After I turned it on today, it suddenly changed to such a…
READ MORE ->
Ezcad Has No Response or Crashes When Opening PLT Files
The most likely reason is that the PLT file is too large.
The Laser Marking Speed Is Very Slow?
The laser marking speed is very slow, and adjust the speed on the right side of the software EzCad does not work? Try changing the fill…
READ MORE ->
The Laser Marking Characters Are Reversed?
The characters marked with the laser marker are reversed. How to adjust? Check if the Use the correction file is not used in the key Param(F3). If you are using…
READ MORE ->
How to Mark the Pattern Lines Thicker?
This is related to the laser outlet. If it is a co2 laser, the line will be slightly thicker by increasing the power. The thickness of the lines marked by fiber…
READ MORE ->
Laser Marking QR Code Is Not Clear?
As shown in the picture, the laser marking QR code in the middle is not clear, and it feels like the QR code is obviously engraved into…
READ MORE ->
How to Print Out the Effect of Embossed Text by Ezcad2?
There are two options for zooming. One is to use a 2D galvo, add a motorized z-axis to achieve zoom, and use EZCAD3+DLC2-2D + to enable the 3d…
READ MORE ->
How to Solve the Problem: EzCad2 Keeps Marking Automatically?
Check Param(F3) – Port – Start Marking IO, see if it is low level, if it is, change it to high level.