The drawing in CAD is correct, and the full filling is ok. I thought it was because the lines overlapped and didn’t connect. However, after…
READ MORE ->
There Is No Response When Clicking Mark Under ProjectMark
If the marking on the main interface is normal, please check whether the Focus Length and Part Diameter are normal.
The Vector Image Will Disappear After Hatch
After the bitmap was converted to a vector graphic, I filled it directly, and the graphic disappeared. After ungrouping, it became dense dots, and there…
READ MORE ->
Ezcad2 Will Stop Working When Opening the Plt Format File
When opening the plt format file, the laser marking software will get stuck, indicating that the MFC Application has stopped working. What is the reason? If the…
READ MORE ->
Why Is There No Spark When Engraving?
The red light shows no problem controlled by Ezcad2, but what is the reason for no spark when engraving? If the marking effect is too…
READ MORE ->
Why Can’t the Edited Drawing in Ezcad Be Saved as a File?
The laser marking card ①should be plugged into the computer, ② must be powered on.
How to Adjust EzCad When the Marking Line Is Too Thin?
Filling(Hatch) is a good method: You can also try in the Mark parameter – Advanced, check the Wobble, increase the spacing; or extend the point time.
Red Vertical Lines Appear in Hatch
Hatch may be enabled twice, or Cross hatch is checked.
How to Make a Vector Graphic to a Double-line Icon That Can Be Filled in Ezcad2?
AI icon files opened in EZCAD become single-line files that cannot be filled in EzCad 2. How can I solve this problem? The CDR x7…
READ MORE ->
How to Just Display Any Object in Ezcad Without Marking It?
Check the “Mark Select” at the bottom of the marking software interface, so that you can select the object to be marked.