Machine Parameter: Port

Input port

1)Input IO mask: Set the input port that the current software allows, and increase or change the input port that can be used.

2)Stable time: Due to interference from signals that may be received by external factors, proper settings can eliminate such as relay jitter.

3)Input IO state: Currently enabled input status.

Start marking IO

1)Port: When the system is not in the marking state, the trigger signal is given to the designated input port. When it is valid, the system will automatically start marking.

2)Active low level: Start marking port active low.

3)Pulse mode: This item indicates that the software processing start signal is pulsed. Even if the input is continuous level, the software reads only one pulse. Otherwise, the processing input is a continuous level.

4)Laser ready: This port is output according to the laser system status. After setting this port, a "power" switch button will be displayed above the "parameters" in the software interface.

5)Red indicate starting port: When the system is not in the red indication state, if the specified input input signal is valid, the output port designated by the red cursor will output a high level, turning on the red light.

6)Door IO: The safe door signal is connected to this port. When the user opens the safety door, it stops processing automatically. Only when the safety door is closed, it can be processed to protect the operator from laser burn.

7)Z layer: In deep carving or 3D printing, the port set when marking the contents of the current layer is marked with a layer when the trigger signal is received, and the extension axis Z axis needs to be enabled for use.

8)port: Set the trigger input port.

Output port

1)Red light pointer: When the system gives a red indication, it will output a high level to the specified output port.

2)Marking output: When the system performs marking process, it will output high level to the specified output port.

3)Out port for laser power: This port can be used to control the laser power on and off.

4)Mark finished: When the system finishes processing, it will output signal to the specified output port.

Z layer

1)Port: In deep carving or 3D printing, when the current layer content is marked, the currently set port outputs the set level signal.

2)Active low level: Yes, the output signal is low; no, the output is high.

3)Pulse width: Output signal time.

4)Stop marking port: Specify an input port as the stop machining port.

When the port receives a signal during machining, the current machining will be terminated and the user will be prompted with an error message.